LED Clock Installer

If you can't install a firmware update over the air, you can use this tool to install it via USB.

1. Connect your LED Clock to your computer with a USB cable.
2. Select the desired firmware version below.
3. Click the 'CONNECT' button.
4. Your browser should prompt to select the correct COM port.
   • Choose the port named 'CPN2102N ....'
   • If no port has been found, make sure the necessary driver is installed.
5. Click on 'INSTALL LED CLOCK'
6. Wait until the installation takes place.
7. Optionally configure Wireless connection.
8. Done!